Hello,
I’m learning to setup my new MOX6 which is a cool machine. I use it mainly in live situation/gigs and for this reason I have choose to make a new SONG in which I have all the VOICE that I need for a band.
Now, I have choose a Hammond VOICE but I want to transpose it to an octave up and include it on a SONG. I have figure out how to transpose it, saving the new SONG to a USR spot and then I put into that SONG, but once I have put it on the SONG the VOICE doesn’t transpose up!
How can I solve this problem?

Another question that I have is that I cannot select from the sources the sustain pedal for changing the Leslie speed.. I cannot find FS(88).. How can I resolve this problem?

Thanks for all your patience and help,
Luca

To have a permanent ‘transpose’, go in ‘mixing’ and next ‘edit’ of your song.
Select the track with the button ‘track’ and next the number of the Hammond sound.
Go in ‘TONE’ (F4), sub function ‘TUNE’ (SF1) and define the ‘NoteShift’ value (12 is up one octave).
Remember to ‘store’ the changes.

FS(88) should be the Assignable Footswitch, not the sustain.
Which is the preset voice number you’ve assigned?

Pino, Italy

And have a look to this article

pomodei - 18 December 2014 04:20 PM

To have a permanent ‘transpose’, go in ‘mixing’ and next ‘edit’ of your song.
Select the track with the button ‘track’ and next the number of the Hammond sound.
Go in ‘TONE’ (F4), sub function ‘TUNE’ (SF1) and define the ‘NoteShift’ value (12 is up one octave).
Remember to ‘store’ the changes.

FS(88) should be the Assignable Footswitch, not the sustain.
Which is the preset voice number you’ve assigned?

Pino, Italy

Ciao Pino,
I don’t know the rule of this forum, but I think it would be better to write in English!
The transpose function that you have explained me works good, so thanks for your help!

I’m trying to make the sustain pedal workin as a leslie “pedal” to the VOICE called 16+8+5&1;/3

Thanks again,
Luca

I don’t know if it is possible to manage the Leslie with the sustain pedal.

I’ve bought a FootSwitch, and plugged it into the Assignable FootSwitch port.
And I use it to control Leslie, accordingly to the setup you can find in this post (have a look at the answer of bad_mister).
In particular, I’ve assigned (Utility/CTL SET) the Modulation Wheel (MW) to the Footswitch (FS), and works fine.

Ciao
Pino