Old Motifator threads are available in the Archive.
matje
Total Posts: 45
Joined 12-12-2012 status: Regular |
Hello, As a newby, this will be an easy question for you (I think). I am totally new in midi world and also in Motif world. I have a Motif XS and a Nord Stage 3. My wish is play on the Motif, but the sound comes from the NS3. How do I configure the Motif? Thanks |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
The answer depends on how the XS will be used. Will the XS be used just to control the Nord, or will the XS also be playing some of its own sounds at the same time? The more detail you can provide, the better the reply is likely to be. |
matje
Total Posts: 45
Joined 12-12-2012 status: Regular |
Is when we play specific songs in my band. For a song I neeneeds the sound of the Nord but play it on the Motif (because of the light wwighted key bed). In that specific song I don’t need any sound if the Motif. For the band I use Forscore. In thus app I have all my scores. Per scires I send a program changes message to the Motif and the Nord. For that specific song I need to send a program change message so that the Motif plays the sound of the Nord. In a gig I dont have time to do a lot of configuration. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
In which mode(s) (Voice, Performance, Pattern, Song, Master) do you use the XS when you gig? |
matje
Total Posts: 45
Joined 12-12-2012 status: Regular |
I use only voice mode on a gig. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
One more question…
|
matje
Total Posts: 45
Joined 12-12-2012 status: Regular |
Is connected by USB |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
I’m going to presume the following…
Connect a 5-pin MIDI cable from the XS MIDI-Out to the Nord MIDI-In.
To satisfy #1, program a Voice on the XS with volume set to 0(zero), and select that Voice when you want to play the Nord. The XS MIDI transmit channel should match the Nord MIDI receive channel. ForScore should send this SysEx message…
Unfortunately, once the XS MIDI In/Out is set to “MIDI”, it won’t respond to messages sent via USB. Therefore to satisfy #2, MIDI In/Out would have to be reset to “USB” manually via Utility Mode. See the XS Owner’s Manual, MIDI Settings - [SF2]MIDI beginning on page 267, especially (4) MIDI In/Out on page 268. |
matje
Total Posts: 45
Joined 12-12-2012 status: Regular |
Thank you for your replies. So to use the XS as an external keyboard, it is only possible to use a midi cable. This does not work over USB? |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
The XS isn’t class compliant - it will work as a controller over USB if connected to a host running the proper driver, and with an application that can route the MIDI data to the keyboard being controlled. As far as I know, forScore runs only on iOS devices. Does your iOS device have what’s needed to route MIDI data from the XS via USB to the Nord? |
matje
Total Posts: 45
Joined 12-12-2012 status: Regular |
I don’t know. It is a matter of trying.
It is not a good idea to set midi manually to USB. I think the only solution is to use a midi interface like the Iconnectmidi2.
|