Old Motifator threads are available in the Archive.
yoyi
Total Posts: 5
Joined 07-25-2018 status: Newcomer |
Hello. My MO6 is detuning by itself after some minutes of playing. Restarting it only works for some minutes, and then it again detunes. Please let me know if any of you have had this issue, and how you have solved it.
Thanks,
|
zpink
![]() Total Posts: 353
Joined 08-02-2014 status: Enthusiast |
Assuming you don’t have anything connected to it that could cause it, the pitchbend would be the prime suspect. Can you set the pitchbend range to zero to see it stays in tune? |
yoyi
Total Posts: 5
Joined 07-25-2018 status: Newcomer |
Ok. I will try that. Do you know if the pitch bend can be set to 0 for a particular sound or in general? |
zpink
![]() Total Posts: 353
Joined 08-02-2014 status: Enthusiast |
On the MoXF, and I assume most synths, it will be per voice.
|
5pinDIN
![]() Total Posts: 10627
Joined 09-16-2010 status: Legend |
For a Voice, set both the Upper and Lower PB range to +0 - see [SF5] OTHER on page 154 of the MO Owner’s Manual. For a Performance or Song/Pattern Mixing, the Receive Switch setting for PB can be turned off for all Parts. See http://www.motifator.com/index.php/forum/viewthread/480102/ |
zpink
![]() Total Posts: 353
Joined 08-02-2014 status: Enthusiast |
It’s never crossed my mind that one could do that!
|
5pinDIN
![]() Total Posts: 10627
Joined 09-16-2010 status: Legend |
The ability to determine certain controller influence per-Part via the Receive Switch setting is common to the Motif family (beginning with the Classic model), including your MOXF.
Thanks, although perhaps I’m more like MacGyver than Legend. ;-) |
zpink
![]() Total Posts: 353
Joined 08-02-2014 status: Enthusiast |
‘Status: McGyver’, yeah that could work too. :-) |