Old Motifator threads are available in the Archive.
rudolph
Total Posts: 8
Joined 04-06-2014 status: Newcomer |
Hello everybody,
I compare them using the same volume level and the same output gain (+6dB) in the Utility/Audio In/Out Settings I/O menù. This a major issue especially in live situations.
What am I doing wrong? Any suggestion?
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
When a Part is routed to an assignable output, the signal is no longer a component of the main mix - it bypasses System/Master Effects and Master EQ, and goes directly to the ASSIGNABLE L and/or R outputs. Therefore any volume level increase that may have been applied to the Part when routed to the main L/MONO and R outputs is not present at the assignable ones. There are a couple of ways to increase the output level for a Part (either in a Performance or Song/Pattern Mixing).
1) The easiest way is to edit Volume for the Part…
2) Part EQ can be used to increase level…
 Low Mid High
If the Part has an EQ curve, increase the Gain settings as needed. 3) Signals sent to assignable outputs are typically processed externally, so using a small mixer to adjust levels is a common way to resolve gain differences. |