Old Motifator threads are available in the Archive.
andyoc
Total Posts: 18
Joined 05-06-2005 status: Regular |
Hello XF users! Just got a new XF7, and am having some difficulties in the arpeggiation department.
I want to record a Trance Vision performance into Cubase.
So then I recorded the individual sysex commands for Arps 1 to 5.
Also, the Main Arp On/Off switch.
All good so far… However, on replay in Cubase, there is no response to these messages from the XF7. I’ve tested the output from Cubase with a Midi monitor, and the messages are being transmitted. Alas, the XF7 does not respond, either via MIDI or USB. Any thoughts?
EDIT: just tried sending the Performance part faders sysex messages, and they are working…
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
It appears you’ve captured the SysEx as it’s transmitted from Port 4. Such messages have the fifth byte set to ”13”. If you change that Model ID byte to ”12” instead, the XF should recognize the messages. |
andyoc
Total Posts: 18
Joined 05-06-2005 status: Regular |
Thanks so much 5pin! That works!
Is getting sysex via Port4 standard on the USB?
Thanx again! |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
You’re welcome!
Â
See MIDI channels and MIDI ports on page 57 of the XF Owner’s Manual. For an XF7, the ports typically are identified in software as MOTIF XF7-1 through MOTIF XF7-4. Careful setup of the ports in computer applications should minimize or eliminate the need to edit the SysEx. |
andyoc
Total Posts: 18
Joined 05-06-2005 status: Regular |
Thanks again, 5pin! |