I have loaded a wav sample at c1 on my MOXf8 . chose a voice to replace went to job initialized it. then i go to edit and i have no OSC. i see name,Main, Sub catigories only.  i have name-SF1 ply modeSF2 portaSF3 otherSF4
GENERAL F1 - OUTPUT F2 - EQ F3 - CONTROL SET F4 - LFO F5 - EFFECT F6

OSC ISN’T SHOWING.

IS THERE SOMETHING I FORGOT OR MISSED?

The problem is, you are in COMMON Edit.

You need to get to ELEMENT Edit: WAVE (Waveform) is a per ELEMENT assignment.

See page 38 of the MOXF Reference Manual.

I found the page but it doesn’t actually say how to change it at least i cant find anything that tells me how

i’ve read it over several times and cant find anything that tells me how to change to elements. very frustrating

Once you hit the Edit Button, you are in COMMON Edit.

To enter ELEMENT Edit, you must then hit the appropriately numbered PART[ELEMENT] button 1-8, to call up the desired ELEMENT for Editing.

See page 15 of the MOXF Owner’s Manual for a chart on using the Numbered Buttons to select ELEMENTS for Editing...as well as other uses for these important buttons.

Thanks got it. i was confused about the part select buttons