Old Motifator threads are available in the Archive.
prooton7
Total Posts: 6
Joined 07-02-2015 status: Newcomer |
Hello, is Moxf reading syx data? (if yes, how configure that) I recording moxf -> to PC, all ok and notes recorded to daw(Reaper) and also arp ON syx (F0 43 10 7F 1C 01 30 30 04 01 F7 ) and arp OFF syx (F0 43 10 7F 1C 01 30 30 04 00 F7) . Now if I start Reaper.. Moxf just play notes back but not starting arp button. How make Moxf response to (arp ON OFF) syx data? thanks. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
The correct SysEx message depends on the mode. Which mode? Normal Voice, Performance, Song/Pattern, Drum Voice? If for Performance mode (you had one byte incorrect)… F0 43 10 7F 1C 00 30 30 04 01 F7 Arp ON F0 43 10 7F 1C 00 30 30 04 00 F7 Arp Off |
MrMotif
Total Posts: 1122
Joined 10-02-2002 status: Administrator |
Is MIDI sync set to external? Check this under UTILITY [F5] MIDI > Sync |
prooton7
Total Posts: 6
Joined 07-02-2015 status: Newcomer |
Thank you! This syx codes working ok now
F0 43 10 7F 1C 00 30 30 04 00 F7 Arp Off I have Moxf6 and perform mode.. |
prooton7
Total Posts: 6
Joined 07-02-2015 status: Newcomer |
>>>If for Performance mode (you had one byte incorrect)… F0 43 10 7F 1C 00 30 30 04 01 F7 Arp ON
F0 43 10 7F 1C 00 30 30 04 00 F7 Arp Off
... but interesting, why my Reaper receives all syx operations from Moxf6 with that 01 bite, not 00 . If I manually changes 01 to 00 and send syx data back to moxf, then all working. If many syx changes, then manually not too good:) |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
Which MOXF Port (number) is Reaper receiving? |
prooton7
Total Posts: 6
Joined 07-02-2015 status: Newcomer |
>Which MOXF Port (number) is Reaper receiving? (win7) my Reaper receiving syx data from port 4 .. and needed midi in channels to: ALL ; (just one midi channel not receive syx data). Can I change Moxf6 data sending port, how? thanks |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
Port 4 is for the Yamaha Editor. What is happening is normal. See these, although not about the MOXF:
You can continue to use Port 4, but you will have to change the Model ID byte in the SysEx.
Or, you can create SysEx messages yourself. See page 121 of the MOXF Data List, (3-6-3-1) NATIVE PARAMETER CHANGE, MODE CHANGE. For device number 1,
If you don’t have the MOXF6/MOXF8 Data List, you can get it here:
|